Skoda Yeti Owner's Manual page 127

The voice command system (hereinafter referred to only as a system) allows
some functions of the GSM II or III GSM universal phone installation kit to be
operated via voice commands.
The period of time during which the system is ready to receive voice com-
mands and to carry them out is called a dialogue. The system gives audible
feedback and guides you if necessary through the relevant functions.
Optimum understanding of the voice commands depends on several factors.
›
Speak with a normal tone of voice without intonation and excessive pauses.
›
Avoid a bad pronunciation.
›
Close the doors, windows and sliding roof, to reduce or stop disturbing exte-
rior noise.
›
You are recommended to speak louder at higher speeds, so that the sound of
your voice is not drowned out by the increased ambient noise.
›
During the dialogue, limit additional noise in the vehicle, e.g. passengers talk-
ing at the same time.
›
Do not speak, if the system makes an announcement.
The microphone for voice control is inserted in the moulded headliner and di-
rected to the driver and front passenger. Therefore the driver and the front
passenger can operate the equipment.
Entering a phone number
The telephone number can be entered as a continuous series of individually
spoken digits (the whole number at once) or in the form of digital blocks (sepa-
rated by short pauses). After each order of digits (separation through brief
voice pause) all of the digits detected up to now are repeated by the system.
The digits 0 - 9, symbols +, , # are permitted. The system detects no continu-
ous digit combinations such as twenty-three, but only individually spoken dig-
its (two, three).
Activating voice control - GSM II
By briefly pressing the button
1
wheel.
Deactivating voice control - GSM II
If the system is currently playing a message, the message that is currently be-
ing played must be terminated by briefly pressing button
multifunction steering wheel.
124
Using the system
» Fig. 119 on the multifunction steering
» Fig. 119
1
If the system is expecting a voice command, you can end the dialogue yourself
as follows.
›
With the voice command CANCEL.
›
By briefly pressing the button
wheel.
Activating voice control - GSM III
The dialogue can be started at any time by pressing the button
the multifunction steering wheel.
Deactivating voice control - GSM III
If the system is currently playing a message, the message that is currently be-
ing played must be terminated by pressing the button
ti-function steering wheel.
If the system is expecting a voice command, you can end the dialogue yourself
as follows.
›
With the voice command CANCEL.
›
By briefly pressing the button
wheel.
Note
The dialogue of an incoming call is immediately interrupted.
Voice commands - GSM II
Basic voice commands
Voice command
HELP
CALL XYZ
PHONE BOOK
CALL HISTORY
on the
DIAL NUMBER
REDIAL
» Fig. 119 on the multifunction steering
1
» Fig. 119
1
» Fig. 119 on the multifunction steering
1
Action
After this command the system repeats all possible
commands.
This command calls up the contact from the phone
book.
After this command, for example, the phone book
can be repeated back to you, a voice entry for the
contact can be updated or deleted, etc.
Lists of dialled numbers, missed calls, etc.
After this command, a telephone number can be
entered to establish a connection with the reques-
ted party.
After this command the system calls the last dial-
led number.
» Fig. 119 on
1
on the mul-
