Parking - Skoda Yeti Owner's Manual

Hide thumbs Also See for Yeti:
Table of Contents

Advertisement

If suitable parking space is found, its parameters are stored until another suit-
able parking space has been found or until a distance of 10 m had been driven
after finding the parking space.
If the driver changes the parking mode while searching for a parking space, the
symbol button  must be pressed again.
Note
If the symbol  (km / h) is shown in the display , the vehicle speed should be
reduced below 40 km / hr (parallel parking) or below 20 km / hr (Transverse

parking) .

Parking
Fig. 142 Display
Read and observe
and
Display
Parking place recognised with the information to drive on.
A
Parking place recognised with the information to engage the reverse gear.
B
Indication for selecting the forward gear.
C
Indication for selecting the reverse gear.
D
If the system has recognised a suitable parking space, this parking space is
shown in the display
» Fig. 142
- .
Continue driving forwards until the display appears
Stop and ensure that the vehicle does not continue to move forward until
the parking procedure starts.
Select reverse gear or move the selector lever into position R.
152
Driving
on page 150 first.
» Fig. 142
- .
As soon as the following message is shown in the display: Steering int. ac-
tive. Monitor area around veh.!, let go of the steering wheel. The steering
will be taken over by the system.
Observe the direct vicinity of the vehicle and reverse carefully.
If necessary, the parking procedure can be continued with further steps.
If the forward arrow flashes
» Fig.
selector lever in position D.
The display shows the  icon (brake pedal).
Depress the brake pedal and wait until the steering wheel automatically ro-
tates into the required position, the symbol  goes out.
Carefully drive forwards.
If the backwards arrow is flashing in the display
gear again or move the selector lever into position R .
The display shows the  icon (brake pedal).
Depress the brake pedal and wait until the steering wheel automatically ro-
tates into the required position, the symbol  goes out.
Carefully move backwards.
You can repeat these steps several times in succession.
As soon as the parking procedure is completed, an audible signal sounds and
the following message appears in the display.
Park Assist ended. Please take over steering!
Automatic brake assist when speeding
If a velocity of 7 km / h is exceeded during the parking manoeuvre for the first
time, the speed will be automatically reduced by the system to less than 7 km /
h. This prevents the parking manoeuvre from aborting.
Automatic termination
The system terminates the parking procedure if one of the following cases ari-
ses.
A speed of 7 km / h is exceeded for the second time.
The time limit of 6 minutes is exceeded.
The system key is pressed.
The TCS system is turned off.
There is a driver intervention in the automatic steering operation (wheel
stop).
When there is a system fault (system temporarily not available).
There is an automatic emergency braking.
142- , then shift to 1st gear or move the
» Fig. 142
- , select reverse

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents