Table of Contents
Advertisement
200 Wheels ›
Tyre pressure
Inflate tyres
›
Fit the tyre inflation hose of the air compressor to
the tyre valve.
›
Secure the vehicle with the parking brake.
›
Start the engine.
›
Plug the connector into the 12 volt socket .
›
Turn on the air compressor.
›
Once a tyre pressure of 2.0-2.5 bar is reached, turn
off the air compressor.
Observe the maximum running time of the air com-
pressor according to the directions of the repair kit
manufacturer.
›
If an air pressure of 2.0 - 2.5 bar has not been
reached, remove the tyre inflation hose from the
valve.
›
Drive approx. 10 metres forwards or backwards to
allow the sealing agent to distribute in the tyre.
›
Replace the tire inflation hose on the valve and re-
peat the inflation procedure.
Tyre pressure
What you should be mindful of
NOTICE
Always adjust the tyre pressure to the load.
▶
Check the pressure in all tyres at least once a
▶
month and before each longer ride.
Check the pressure when the tyres are cold. If nec-
▶
essary, do not reduce the elevated pressure when
the tyres are warm.
After each tyre pressure change, save the new val-
▶
ues in the tyre pressure monitoring system.
WARNING
Risk of an accident!
If tyre pressure loss is very quick, try to stop the ve-
hicle carefully without heavy steering or heavy brak-
ing.
Sticker with prescribed tyre pressures
The sticker with prescribed tyre pressures is located
on the inside of the fuel filler flap.
Inflation pressure for
A
half load
Inflation pressure for
B
environmentally
friendly operation
(slightly lower fuel
consumption and
emissions)
Inflation pressure for
C
full load
Tyre diameter in inches
D
This information only serves as information for
the prescribed tyre pressure. This is not a listing
of approved tyre sizes for your vehicle. These
are listed in the technical vehicle documentation
and in the declaration of conformity (in the so-
called COCDocument).
Tyre pressure reading for the front axle tyres
E
Tyre pressure reading for the rear axle tyres
F
Prescribed tyre pressure value for the emergen-
G
cy wheel
Tyre pressure monitoring system
Functionality
The tyre pressure monitoring indicator indicates a
change in tyre pressure.
Warning when pressure changes
Illuminated - Tyre pressure change
›
Stop the vehicle.
›
Check the tyres and tyre pressures.
Show tyres with modified pressure
›
In Infotainment, select the following menu.
Vehicle status
Or:
Vehicle status
Function restriction
The system is unable to provide a warning in the
event of a very rapid tyre pressure loss, e.g. sudden
puncture.
The system function may be restricted in the follow-
ing cases.
Uneven loading of the wheels, e.g. with a trailer at-
▶
tached.
Sporty driving style.
▶
Driving on dirt roads.
▶
Snow chains fitted.
▶
Saving tyre pressure values
Store the tyre pressure values in the infotainment
›
Inflate the tyres to the prescribed inflation pres-
sure.
›
Turn on the ignition.
›
In Infotainment, select the following menu.
Vehicle status
Or:
Advertisement
Table of Contents
