Skoda Yeti Owner's Manual page 44

Hide thumbs Also See for Yeti:
Table of Contents

Advertisement

If the warning light
flashes again after the engine has started, there is a
system error.
Seek help from a specialist garage.
The following reasons can explain the warning light
The vehicle is loaded on one side. Distribute loads as evenly as possible.
The wheels of one axle are loaded more heavily (e.g. when towing a trailer or
when driving uphill or downhill).
Snow chains are mounted.
A wheel has been changed.
Save the tyre pressure values in the system
CAUTION
Under certain circumstances (e.g. sporty style of driving, wintry or unpaved
roads) the warning light
can be delayed or does not light up at all.
Note
If the vehicle's battery has been disconnected and reconnected, the warning
light
comes on after switching on the ignition. If the indicator light does not
go out after moving a short distance, this means that there is an error in the
system. Seek help from a specialist garage.
Windscreen washer fluid level
Read and observe
on page 35 first.
If the windscreen washer fluid level is too low, the warning light
nates.
The following message is shown in the MAXI DOT display.
Top up wash fluid!
Top up with liquid
» page
182, Windscreen washer system.
Turn-signal system
 
Read and observe
on page 35 first.
Either the left
or right
warning light flashes depending on the position of
the turn signal lever.
If there is a fault in the turn signal system, the warning light flashes at twice
its normal rate. This does not apply when towing a trailer.
being illuminated.
» page
158.
illumi-
Switching off the hazard warning light system is switched on will cause all of
the turn signal lights as well as both warning lights to flash.
Fog lights
Read and observe
on page 35 first.
The warning light
illuminates when the fog lights are operating.
Cruise control system
Read and observe
on page 35 first.
The warning light
illuminates when the cruise control is active
Brake pedal (automatic gearbox)
Read and observe
on page 35 first.
If the warning light
illuminates, operate the brake pedal.
OFF ROADmode
Read and observe
on page 35 first.
When the indicator light
is lit, then the conditions for the engagement of
OFF ROAD mode are met
» page 144
When the indicator
flashes, it indicates the hill descent assistant is current-
ly engaged.
Further information
» page
144, OFF ROAD-mode.
Main beam
Read and observe
on page 35 first.
The warning light
illuminates when the main beam or the headlight flasher
is operated.
» page
.
Instruments and Indicator Lights
154.
41

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents