Wi-Fi - Skoda Yeti Owner's Manual

Wi-Fi


Introduction
This chapter applies only to vehicles with the GSM III universal telephone in-
stallation kit.
This chapter contains information on the following subjects:
Switching Wi-Fi network on/off
Connecting an external device to the WLAN network
Use WLAN network in MAXI DOT display
WLAN (also Wi-Fi) is a wireless network for connecting to the Internet.
Using a mobile phone connected with the universal telephone preparation
GSM III via the rSAP profile, it is possible to establish a Wi-Fi network in the ve-
hicle and to enable passengers with compatible devices to connect to this net-
work.
Switching Wi-Fi network on/off
Switching on
›
Connect the mobile phone with the universal telephone preparation GSM III
via the rSAP profile » page 119.
›
Select the Wi-Fi menu item in the Phone menu.
The display shows the message Swith on Wi-Fi??
›
Select the Yes menu item.
If no access point is assigned automatically, then this must be entered man-
1)
ually as per the instructions from the mobile network operator, e.g. "Internet".
If the Wi-Fi network is switched on, the display will show the following mes-
sage, for example: WLAN SK_WLAN 1234 switched on.
The display then shows a password for the Wi-Fi network connection. The
password can subsequently be found in the Phone - Wi-Fi - Password - Show
menu.
1)
The name of the access point is defined by the mobile operator.
122
Using the system
If no data connection via WLAN is available, the display will show the message
Data connection not available.. This can be caused by a weak GSM signal, for
example. Try to establish the connection again at a location with stronger sig-
nal reception.
Switching off
›
Select the Wi-Fi - Off menu item in the Phone menu.
The display shows the message Switch off Wi-Fi?
122
›
Select the OK menu item.
122
The display shows the message Wi-Fi switch off.
123
Connecting an external device to the WLAN network
Connecting using the Wi-Fi network search
›
Switch on the Wi-Fi network
›
On the device to be connected, search for available WLAN networks (Wi-Fi) -
see operating instructions for the device to be connected.
›
Select the appropriate Wi-Fi network connection in the menu of the net-
works found (e.g. Wi-Fi SK_WLAN 1234).
If menu item WPA2 is set in the Phone - Wi-Fi - Settings - Encryption menu,
then the password displayed when the Wi-Fi is switched on must be entered
in the device to be connected. The password can be found in the Phone - Wi-Fi
- Password - Show menu.
If menu item Open is set in the Phone - Wi-Fi - Settings - Encryption menu,
the connection is made automatically.
Connecting using WPS (service for easy connection)
›
Switch on the Wi-Fi network
›
Open the Phone - Wi-Fi - WPS config. menu in the instrument cluster.
›
In the device to be connected, select the connection using WPS function -
see operating instructions for the device to be connected.
If the Pushbutton menu item is selected in the instrument cluster, the Wi-Fi
connection is made automatically.
If the WPS PIN menu item is selected in the instrument cluster, then a PIN
must be entered in the device to be connected and the instrument cluster.
» page 122, Switching Wi-Fi network on/off.
» page 122, Switching Wi-Fi network on/off.