Skoda Yeti Owner's Manual page 65

Operation of the sliding / tilting roof
Open fully

Open partially
A
Comfort position

Opening (switch in position  )
1
Closing (switch in position  )
2
When the sliding/tilting roof is in the comfort position, the intensity of the
wind noise is reduced.
Force limiter
The sliding/tilting roof is fitted with a force limiter. The sliding/tilting roof
stops and moves back several centimetres when it cannot be closed because
there is something in the way (e.g. ice). The sliding / tilting roof can be fully
closed without a force limiter by pulling on the recess in the switch in the ar-
row direction » Fig. 43 until the sliding / tilting roof is fully closed .
2
WARNING
When operating the sliding/tilting roof, proceed with caution to avoid caus-
ing crushing injuries – risk of injury!
CAUTION
During the winter it may be necessary to remove any ice and snow in the vicin-
ity of the sliding/tilting roof before opening it to prevent any damage to the
opening mechanism.
Sliding / tilting roof malfunction

Read and observe on page 61 first.
If, for example, the battery has been disconnected and reconnected, it is possi-
ble that the sliding/tilting roof will not operate correctly. The sun roof must be
activated.
Activation sequence:
›
Switch on the ignition.
›
Set the switch to the position 
›
Press the switch on the recess E down and pull forwards.
›
The sliding/tilting roof opens and closes again after around 10 seconds.
›
Release the lever.
62
Using the system
» Fig. 43
» Fig. 43 on page 61.
Opening/closing the sun screen

Read and observe on page 61 first.
The sliding sun blind (hereinafter only referred to as a sun screen) can be
opened or closed using the buttons.
Operation of the sun blind » Fig. 44
Opening

Closing

Press the button to fully open or close.the sun blind. The movement of the sun
blind can be stopped by briefly pressing any key.
By pressing and holding the button, the sun blind is opened or closed in the
desired position. By releasing the button, the opening or closing operation is
stopped.
WARNING
When operating the sun blind, proceed with caution to avoid causing crush-
ing injuries – risk of injury!
Malfunction of the sun blind

Read and observe on page 61 first.
If, for example, the battery has been disconnected and reconnected, it is possi-
ble that the sun blind will not operate correctly. The sun blind must be activa-
ted.
Activation sequence.
›
Switch on the ignition.
›
Set the switch to the position 
Fig. 44
Operation of the sun blind
» Fig. 44 on page 62.
