Operation In Vehicles With Manual Gearbox; Operation In Vehicles With Automatic Gearbox; System Related Automatic Start-Up - Skoda Yeti Owner's Manual

Note
If the vehicle remains outdoors for a long time in minus temperatures or in
■
direct sunlight, it can take several hours until the internal temperature of the
vehicle battery reaches a suitable temperature for proper operation of the
START STOP system.
If the driver's seat belt is removed for more than approx. 30 seconds or the
■
driver's door is opened during stop mode, the engine will have to be started
manually.
After the manual engine start and with a manual gearbox the automatic en-
■
gine shutdown can take place only when a minimum distance required for the
system function has been covered.

Operation in vehicles with manual gearbox


Read and observe on page 155 first.
In compliance with the operating conditions, automatic engine shutdown / au-
tomatic engine start takes place as described.
Automatic engine shutdown
›
Stop the vehicle.
›
Put the gear stick into Neutral.
›
Release the clutch pedal.
Automatic engine shutdown takes place, segment display shows START-STOP
ACTIVE or a check mark appears in the MAXI DOT display 
page 155.
Automatic engine start
›
Depress the clutch pedal.
The automatic start procedure takes place again.

Operation in vehicles with automatic gearbox


Read and observe on page 155 first.
In compliance with the operating conditions, automatic engine shutdown / au-
tomatic engine start takes place as described.
Automatic engine shutdown
›
Bring the vehicle to a stop and depress the brake pedal.
156
Driving
Automatic engine shutdown takes place, segment display shows START-STOP
ACTIVE or a check mark appears in the MAXI DOT display 
page 155.
Automatic engine start
›
Release the brake pedal.
The automatic start procedure takes place again.
Further information on automatic transmission
The automatic engine shut down takes place when the selector lever is in po-
sitions P, D, S and N and in Tiptronic mode.
When the selector lever is in position P the engine remains shut down after
you release the brake pedal. The engine starts automatically by pressing the
gas pedal or by moving the selector lever into a different mode and releasing
the brake pedal.
If the engine is off due to the automatic and the selector lever is put to the R
position then the automatic starts the engine.
If the gear selector is moved from position R to the position D, S or N, the vehi-
cle must reach a speed of more than 10 km / h before the automatic engine
shutdown starts.
There is no automatic engine shutdown when the system detects a vehicle
moving due to a large steering angle.
No automatic engine shutdown takes place when the vehicle is moving at low
» Fig. 144 on
speed (e.g. during a traffic jam or when tuning) and remains stationary after
pressing the brake pedal lightly. Automatic engine shutdown takes place if you
press the brake pedal down with more force.

System related automatic start-up


Read and observe
When the engine is off, the system can automatically start the engine before
the desired journey continues. Some possible reasons for this are:
›
The vehicle begins to roll, e.g. on a slope.
›
The brake pedal has been actuated several times.
›
The current consumption is too high.
on page 155 first.
» Fig. 144 on