Replacing Bulbs - Skoda Yeti Owner's Manual

No.
21 Lambda probe
22 Clutch pedal switch, brake pedal switch
Coolant pump
Solenoid valve for charge pressure control, change-over valve for
23
cooler
High-pressure fuel pump
24 Active charcoal filter, exhaust gas recirculation valve, radiator fan
25 ABS control unit
26 Vehicle voltage control unit, left headlight, left tail light
27 Glow plug system
28 Windscreen heater
29 Power to the internal fuse carrier
30 Terminal X
a)
a)
In order not to drain the battery unnecessarily when starting the engine, the electrical components of
this terminal are automatically switched off.

Replacing bulbs


Introduction
This chapter contains information on the following subjects:
Bulb arrangement in the headlights
Change bulb for low beam and high beam
Remove the protective grille for fog lights
Remove the protective grille for fog lights - sensor plug for parking
assistance
Replacing the bulb for the fog lights
Replacing the bulb for the licence plate light
Rear Light
Replacing bulbs in rear light
Some manual skills are required to change a bulb. For this reason, we recom-
mend having bulbs replaced by a specialist garage or seeking other expert help
in the event of any uncertainties.
Consumer
›
Switch off the ignition and all of the lights before replacing a bulb.
›
Faulty bulbs must only be replaced with the same type of bulbs. The designa-
tion is located on the light socket or the glass bulb.
›
A stowage compartment for replacement bulbs is located in a box under the
floor covering in the luggage compartment.
WARNING
Always read and observe the warnings before completing any work in the
■
engine compartment » page
Accidents can be caused if the road in front of the vehicle is not suffi-
■
ciently illuminated and the vehicle cannot or can only be seen with difficul-
ty by other road users.
Bulbs H7 and H4 are pressurised and may burst when changed - there is a
■
risk of injury. We therefore recommended wearing gloves and safety
glasses when changing a bulb.
Gas discharge bulbs (xenon bulbs) operate with a high voltage, professio-
■
nal knowledge is required – risk of death!
Switch off the respective vehicle light when changing the bulb.
■
CAUTION
Do not take hold of the glass bulb with naked fingers (even the smallest
amount of dirt reduces the working life of the light bulb). Use a clean cloth,
napkin, or similar.
Note
This Owner's Manual only describes the replacement of bulbs where it is pos-
218
■
sible to replace the bulbs on your own without any complications arising. Other
218
bulbs must be replaced by a specialist garage.
218
We recommend that a box of replacement bulbs always be carried in the ve-
■
hicle. Replacement bulbs can be purchased from ŠKODAOriginal Accessories.
219
We recommend having the headlight settings checked by a specialist garage
■
219
after replacing a bulb in the main beam, low beam or fog lights.
220
In case of failure of a xenon gas discharge lamp or an LED diode, visit a spe-
■
220
cialist garage.
221
180.
Fuses and light bulbs
217