Remove the protective grille for fog lights - sensor plug for
parking assistance
Fig. 200 Guard: Version 1/version 2
Fig. 201 Remove the plug
Read and observe
and
›
Remove the plastic cover for the guard in the arrow direction
the bow to pull the full wheel covers
›
Remove the remaining part of the grille.
›
Pull the latch out of the connector in the direction of arrow
›
Undo the latch on the connector in the direction of arrow
›
Remove the key in the direction of the arrow
The connector is installed in reverse order.
1)
Applies to vehicles with parking assistance system.
on page 217 first.
» Fig. 200
» page
198, Vehicle tool kit.
» Fig.
1
.
2
.
3
Replacing the bulb for the fog lights
Fig. 202 Principle sketch: Remove the number plate light / replace the
bulb
Read and observe
First remove the grille for the fog lights and before changing bulbs
on page 218 and / or
Remove the headlight
›
Unscrew the two bolts
›
Remove the headlight in the direction of arrow
›
Remove the headlight in the direction of arrow
Replacing the light bulb
›
Pull the plug on the lamp base.
›
Turn the lamp socket to the stop in the direction of arrow
pull it out.
›
Insert the bulb holder with the new bulb into the headlight and turn counter
to the direction of arrow
›
using
Attach the connector on the lamp base.
Refit the headlight and grille
›
Replace the fog light by inserting it in the opposite direction of the arrow
201.
» Fig. 202
and tighten.
2
›
Attach the connector on guard carefully
›
Insert the protective grille and press it in.
›
Replace the plastic cover and press into the guard
The protective grille must engage firmly.
and
on page 217 first.
» Fig. 200
on page 219.
» Fig. 202
with the screwdriver
A
.
1
.
2
as far as the stop.
3
» Fig. 201
on page 219
» Fig. 200
Fuses and light bulbs
» Fig. 199
» page
198.
» Fig. 202
and
3
.
1)
on page 219
.
1)
219