Skoda Yeti Owner's Manual page 151

Hide thumbs Also See for Yeti:
Table of Contents

Advertisement

Approximate range of sensors (in cm)
Area
» Fig. 136
Version 1
(4 sensors)
-
A
-
B
160
C
60
D
-
E
Audible signals
The interval between the acoustic signals becomes shorter as the clearance is
reduced. A continuous tone sounds from a distance of approx. 30 cm - danger
area. From this moment on do not continue driving!
Towing a trailer
On vehicles equipped with a factory-fitted towing device, only system areas
and
» Fig. 136
are active when towing a trailer.
B
Note
If with Version 3 vehicles not all fields around the vehicle are active after ac-
tivation the vehicle should be moved forwards or backwards.
The signal tones for front obstacle recognition are factory-set to be higher
than for rear obstacle recognition.
The sound of the park-assist can be adjusted via the MAXI DOT display in the
Assistants menu option
» page
47.
Shown in the infotainment display
148
Driving
Version 2
Version 3
(8 sensors)
(12 sensors)
120
120
60
60
160
160
60
60
-
60
Fig. 138
Display
Read and observe
and
Function keys and obstacle warning
Change to rear-view camera display .
Switching off park assistant display.
Switching audible parking signals on / off.
  
Message: Look! Safe to move?
An area without detected obstacles is shown as a transparent segment.
A
An obstacle which is currently outside of the collision area is shown by the
B
yellow segment
An obstacle in the collision zone is shown as an orange-coloured segment.
C
Stop driving in the direction of an obstacle!
Activation/deactivation
Read and observe
and
A
The system is automatically activated by selecting reverse gear or pressing
the symbol button 
» Fig. 136
This is confirmed by a short acoustic signal ( the symbol  in the button is lit).
On vehicles with Version 1, the system can be deactivated by moving out of re-
verse gear.
For vehicles with the Version 2 and 3 the system is automatically deactivated
by pressing the symbol key or at a speed over 15 km / h (the symbol in the
button goes out).
Fault display
If a warning signal sounds for about 3 seconds after activating the system and
there is no obstacle close to your car, this indicates a system fault. The fault is
also indicated by the symbol  flashing in the button. Seek help from a spe-
cialist garage.
Note
The system can only be activated with the symbol key at a speed of below
15 km / hr.
on page 147 first.
» Fig. 138
on page 147 first.
on page 147 .

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents