Above the storage compartment the input marked with the text
MDI» page 127
input.
WARNING
The storage compartment is not a substitute for the ashtray and must also
not be used for such purposes – risk of fire!
Cup holders
Fig. 78 Cup holders: in the center console, front / on the folding table in
the center backrest
Fig. 79 Open cup holder in the central console / adjust holder size
Read and observe
on page 86 first.
Cup holders
» Fig. 78
and
» Fig. 79
Cup holder in front centre console
A
Cup holder on the folding table
B
Location for opening
C
88
Using the system
Cup holder in rear centre console
D
Fuse plate
E
Open holder in the rear center console
›
Press in the cup holder in area
The holder slides out.
›
Pull the holder until it stops in the arrow direction
›
Adjust the bracket by sliding the locking plate
Close holder in the rear center console
›
Remove the waste container in the opposite direction to the arrow
» Fig.
79.
1
WARNING
Do not use any cups or beakers which are made of brittle material (e.g.
■
glass, porcelain). This could lead to injuries in the event of an accident.
Never put hot beverage containers in the cup holder. If the vehicle moves,
■
they may spill – risk of scalding!
CAUTION
Do not leave open beverage containers in the cup holder during the journey.
■
There is a risk of spilling e.g. when braking which may cause damage to the
electrical components or seat upholstery.
Before folding the rear center seat cup holder
■
there is risk of damage.
Note
A 1.5 litre bottle (max. capacity) can be stored in the drinks holder
» Fig.
79.
C
.
1
in the direction of arrow
E
» Fig. 79
must be closed -
D
.
2
» Fig.
79.
D