Printing The Batch Count; Clearing The Batch Count - Pitney Bowes DM100i Operator's Manual

Checking and Clearing the Batch Count

Printing the Batch Count

1. Press Funds.
2. Press Page Down twice and select "Print Funds Report".
3. At the "Please insert envelope or tape sheet to print report"
prompt, place the envelope/tape sheet up against the back wall of
the sys tem and slide it to the right until the sys tem grasps it. The
Funds Reports is printed and the envelope/tape strip is ejected.
Used:
Available:
Total Pieces: 735
Control Sum: $464 . 270
– the total of all postage ever used in the meter
Used
– the amount of postage left in the meter
Available
Total Pieces
meter that had postage applied
Control Sum
the amount Used plus Available funds. This is a postal requirement
that verifies an accurate accounting of postage in your meter.
Batch Count
plied since the last time the batch count was cleared
Batch Value
the batch value was cleared
PBP Serial No.
number)
4. Press Home to return to the Home screen.

Clearing the Batch Count

IMPORTANT: Make sure you really want to clear the batch count;
once you do, you can't re store the data.
1. Press Funds.
2. Press Page Down and select "Clear batch values".
3. At the "Confirm Clear" prompt, press Yes/Enter to confirm. The
batch value and batch piece registers return to zero
4. Press Home to return to the Home screen.
SV62276 Rev. D
$464 . 270
$000 . 000
– the total number of mail pieces run through the
– the total of all postage refills for the meter. It equals
– the number of mail pieces that had postage ap-
– the amount of postage applied since the last time
– serial number of this meter (normally meter
3 • Running Mail
Batch Count: 733
Batch Value: $464 . 270
PBP Serial No.: 0011969
JAN 07 08
9:5 5P
3-11