CarE & ClEanIng
ClEanIng tHE StEam Wand
Run steam to clear milk
Wipe steam wand after
from wand after texturing
The steam wand should always be cleaned
after texturing milk.
Wipe the steam wand with a damp cloth,
and then with the steam wand directed
back into the drip tray, briefly set the
steam dial to the STEAM position. This
will clear any remaining milk from
inside the steam wand.
Ensure the steam dial is in the STANDBY
position. Press the POWER button to Off
and allow the machine to cool.
ClEanIng / UnBloCKIng tHE fIltErS, PortafIltEr and groUP HEad
Periodically run water through the machine with the portafilter in place, but without any
ground coffee, to rinse out any residual coffee particles.
Knock grinds out
Clean filter basket
Should the fine holes in the filters become
blocked follow the following steps:
Place the filter into the portafilter.
Run water through the machine with
the filter and portafilter, without any
ground coffee, in place.
The fine pin on the cleaning tool can
be used to clear the filter basket holes.
Clean hole with pin
Place filter basket into
Insert & lock portafilter
into Group Head
Soak tip overnight then
If the steam wand remains blocked,
use the pin on the cleaning tool to clear
If the steam wand continues to be
blocked, the tip of the steam wand can
be removed by using the spanner in the
middle of the cleaning tool.
Unscrew the tip with the cleaning tool.
Soak the tip in hot water before using
the pin on the cleaning tool to unblock.
Replace the tip back onto the steam
wand and secure with the cleaning tool.
PRESS & HOLD
Use cleaning tool to unblock
Repeat steps C1-C2
To clean the Single Wall filters
simply run water through the
portafilter using the manual pour
function by holding down the
1 CUP button.
For a thorough clean of the filters,
run a cleaning cycle of the machine
with the portafilter and filter in place.