Care & Cleaning; Cleaning Cycle; Cleaning The Steam Wand - Sage Dual Boiler BES920 Quick Manual

CARE & CLEANING PAGE HEADER.....
CLEAN ME!
The machine will detect when 200 extractions have
been carried out since the last clean cycle.
The CLEAN ME! icon will be displayed
on the LCD screen the next time the machine
enters START UP mode.

CLEANING CYCLE

• CLEAN ME! will be displayed on
LCD to indicate when a cleaning cycle
is required (approx. 200 shots).
• Insert the supplied cleaning disc, followed by
1 cleaning tablet into the 1 CUP filter basket.
• Insert the portafilter and lock into
group head.
• Ensure the water tank is filled with
cold tap water.
• Ensure the drip tray is empty & inserted.
• Press MENU button until CLEAN CYCLE
icon flashes and PUSH is displayed on
the LCD screen.
• To start the Clean Cycle press the illuminated
MANUAL button.
• The CLEAN CYCLE icon will flash and
the machine will start to countdown from
370 seconds.
• When the cleaning cycle has finished,
remove the portafilter and ensure the tablet
has completely dissolved. If the tablet has
18
not dissolved, repeat the steps above,
without inserting a new tablet.
• Rinse the filter basket and portafilter
thoroughly before use.
INSTALLING WATER FILTERS
• Soak filter in a glass of water for 5 minutes.
• Rinse the filter and mesh under running water.
• Assemble filter into filter holder.
• Set replacement date forward 2 months.
• Install filter holder into water tank.
• Insert water tank into the machine. Ensure the
latch is locked into position.
• Replacing the water filter after three months
or 40L will reduce the need to descale the
machine. The limitation of 40L is based on
water hardness level 4. If you are in level 2
area, you can increase this to 60L.
NOTE
To purchase water filters visit Sage
webpage.

CLEANING THE STEAM WAND

• Wipe the steam wand with a damp cloth &
purge directly after texturing the milk.
• If the any of the holes in the tip of the steam
wand become blocked, ensure the STEAM
LEVER is in the CLOSED position and clean
using the pin on the end of the cleaning tool.
• If steam wand remains blocked, remove the tip
using the integrated spanner in the cleaning
tool and soak in hot water. Screw tip back onto
the steam wand using the integrated spanner
in the cleaning tool.
CLEANING THE FILTER BASKETS
AND PORTAFILTER
• The filter baskets and portafilter should be
rinsed under hot water directly after use to
remove all residual coffee oils.
If the holes in the filter baskets become
blocked, dissolve a cleaning tablet
in hot water and soak filter basket
and portafilter in solution for approx.
20 minutes. Rinse thoroughly.
®