OPERATING INSTRUCTIONS
START-UP AND CHECK
Before proceeding with the start up verify the
following:
•
Open the door(s) and verify that all packaging
materials and tie downs have been removed.
•
Verify that the scrap and pump screens are
properly located.
•
Verify that the drain stopper is closed and that the
linkage is free.
•
Check that the plugs are securely screwed into the
ends of the wash arms.
•
Check that the wash arm is securely screwed into
the base and that the arm rotates freely.
•
Check that the external scrap screen is installed.
•
Check the levels of all chemical containers.
Replace if necessary.
•
Verify that the incoming voltage is correct.
INSTALLATION START-UP PROCEDURE
•
Turn the glasswasher ON/OFF switch to the OFF
position.
•
Turn the Glasswasher DE-LIME switch to the OFF
position.
•
Turn the Glasswasher cycle time switch to the STD
position.
•
Turn the water supply to the unit ON and check for
leaks.
•
Turn the electric power supply to the glasswasher
ON
•
Turn the Glasswasher ON/OFF switch to the ON
position.
•
After a slight delay the water solenoid valve
opens and the glasswasher fi lls.
•
The cycle light will be on while the fi ll solenoid
is energized.
•
Confi rm water supply pressure. (22-24 psi)
•
After the fi ll solenoid valve shuts off check the
water level.
•
The water level should be at the lowest edge
were the back and bottom of the sump meet.
Adjust water level by adjusting incoming water
supply to 22-24 psi.
GW_40TM09
®
12
PART 3 OPERATING INSTRUCTIONS
•
Press the PRIME switch for the detergent and hold
it until there is detergent dropping into the fi ll box of
the Glasswasher sump.
•
Repeat for the Sanitizer and rinse-aid systems.
•
With the door(s) closed press the cycle start switch
(located near door handle on right side panel of
Glasswasher) (Double door units have cycle start
switches on both sides).
•
The following occurs:
•
Cycle light comes ON
•
Pump starts for the wash cycle
•
Detergent dispenses into fi ll box.
•
After wash time is fi nished
•
Drain opens and water drains into the
external scrap screen and goes to the building
drain.
•
Drain closes
•
Sump fi lls with water through the fi ll box.
•
Sanitizer dispenses into fi ll box
•
Rinse-Aid dispenses into fi ll box.
•
After fi ll cycle is fi nished
•
Pump starts for the rinse cycle
•
After rinse cycle is fi nished
•
Cycle light goes OFF
•
Optional clean light (green) comes on and
stays on until a door is opened
NOTE:
Pump stops when door is opened but the
cycle continues
www.insingermachine.com
800-344-4802