Related Manuals for Insinger GW-40 BarMaster
Summary of Contents for Insinger GW-40 BarMaster
- Page 1 ® TECHNICAL MANUAL GLASSWASHER GW-40 BarMaster GW-40-D BarMaster Installation, Operation and Maintenance Instructions Insinger Machine Company 6245 State Road Philadelphia, PA 19135-2996 800-344-4802 Fax 215-624-6966...
- Page 2 When referring to this equipment please have this Operating Instructions information available. Part 4 Each piece of equipment at Insinger is carefully Cleaning/General Maintenance tested before shipment for proper operation. If the need for service should arise please contact your 15-16 local Authorized Insinger Service Company.
- Page 3 ® PART 1 TECHNICAL INFORMATION GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 4 ® PART 1 TECHNICAL INFORMATION GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 5 ® PART 1 TECHNICAL INFORMATION GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 6 ® PART 1 TECHNICAL INFORMATION GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 7 ® PART 1 TECHNICAL INFORMATION GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 8 ® PART 1 TECHNICAL INFORMATION GW_40TM09 www.insingermachine.com 800-344-4802...
-
Page 9: Intended Use
® PART 1 TECHNICAL INFORMATION GW-40 BARMASTER GLASSWASHER Intended use The Insinger GW-40 or GW-40-D may only be used INTRODUCTION for cleaning glasses, cups and similar restaurant Purpose ware and commercial catering. Any change in design or use of the glasswasher car-... - Page 10 15 months from the date is not responsible nor liable for any conditions of shipment from Insinger or 1 year (12 months) of erosion or corrosion caused by corrosive from the date of installation or start-up that said...
- Page 11 fi re, fl ood, or improper maintenance said Insinger product shall be free from defects in or service, or failure to perform normal and routine material and workmanship.
-
Page 12: Installation And Connection
® PART 2 INSTALLATION AND CONNECTION INSTALLATION AND CONNECTION Check for Completeness: Connection to the Drain: After unpacking the machine, fi rst check the delivery The unit is equipped with a 2” OD drain connection against the packing slip to ensure that it is complete, and must be connected to drain capable of handling and inspect for damage that may have occurred a 9.0 gal/min fl... -
Page 13: Grounding Instructions
® PART 2 INSTALLATION AND CONNECTION INSTALLATION AND CONNECTION A 120 volt, 60 Hz, AC only, 20 amp, fused electrical Before using the washer, check that all electrical supply is required. A time-delay fuse or circuit breaker protection systems are working correctly. is recommended. -
Page 14: Operating Instructions
® PART 3 OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS START-UP AND CHECK • Press the PRIME switch for the detergent and hold it until there is detergent dropping into the fi ll box of Before proceeding with the start up verify the the Glasswasher sump. - Page 15 ® PART 3 OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS The RED tube is for a non chlorinated, non foaming, NOTE: commercial detergent recommended for your Glasswasher by your local detergent/chemical Pump stops when the door is opened but supplier. cycle does not stop. The CLEAR/WHITE tube is for a chemical sanitizer using a sodium hypochlorite solution or a iodine DE-LIME...
-
Page 16: Daily Cleaning
® PART 4 CLEANING/GENERAL MAINTENANCE CLEANING/GENERAL MAINTENANCE Daily Cleaning: NOTE: • At the end of each day, or 8 hours Clean the scrap tray after every use period or more frequently during heavy usage • Drain the machine by depressing the manual drain times. -
Page 17: Troubleshooting
® PART 5 MAINTENANCE AND REPAIR PROCEDURES TROUBLESHOOTING ▲ Faults where it is not necessary to call Insinger. WARNING: You can rectify minor faults yourself following the steps described in the table below. If you are unable Turn off the main switch on the dishwasher... - Page 18 ® PART 5 MAINTENANCE AND REPAIR PROCEDURES TROUBLESHOOTING Problem Cause Remedy Poor washing results Clogged spray nozzles and dirty sump tank Clean wash arm and unit Spray arm not revolving Remove and clean arm, shaft, and bushing Low water level Adjust fi...
- Page 19 PART 6 ELECTRICAL SCHEMATICS ® & REPLACEMENT PARTS GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 20 PART 6 ELECTRICAL SCHEMATICS ® & REPLACEMENT PARTS GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 21 PART 6 ELECTRICAL SCHEMATICS ® & REPLACEMENT PARTS GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 22 PART 6 ELECTRICAL SCHEMATICS ® & REPLACEMENT PARTS GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 23 PART 6 ELECTRICAL SCHEMATICS ® & REPLACEMENT PARTS GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 24 PART 6 ELECTRICAL SCHEMATICS ® & REPLACEMENT PARTS GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 25 PART 6 ELECTRICAL SCHEMATICS ® & REPLACEMENT PARTS GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 26 PART 6 ELECTRICAL SCHEMATICS ® & REPLACEMENT PARTS GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 27 PART 6 ELECTRICAL SCHEMATICS ® & REPLACEMENT PARTS GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 28 PART 6 ELECTRICAL SCHEMATICS ® & REPLACEMENT PARTS GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 29 PART 6 ELECTRICAL SCHEMATICS ® & REPLACEMENT PARTS GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 30 PART 6 ELECTRICAL SCHEMATICS ® & REPLACEMENT PARTS GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 31 PART 6 ELECTRICAL SCHEMATICS ® & REPLACEMENT PARTS GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 32 PART 6 ELECTRICAL SCHEMATICS ® & REPLACEMENT PARTS GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 33 PART 6 ELECTRICAL SCHEMATICS ® & REPLACEMENT PARTS GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 34 PART 6 ELECTRICAL SCHEMATICS ® & REPLACEMENT PARTS GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 35 PART 6 ELECTRICAL SCHEMATICS ® & REPLACEMENT PARTS GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 36 PART 6 ELECTRICAL SCHEMATICS ® & REPLACEMENT PARTS GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 37 PART 6 ELECTRICAL SCHEMATICS ® & REPLACEMENT PARTS GW_40TM09 www.insingermachine.com 800-344-4802...
- Page 38 ® Insinger Machine Company 6245 State Road Philadelphia, PA 19135-2996 800-344-4802 Fax 215-624-6966...