Advertisement
OPERATING INSTRUCTIONS
NOTE:
Pump stops when the door is opened but
cycle does not stop.
DE-LIME
•
Open the door and remove any glassware rack that
may have been left in the washer.
•
Manually add to the water in the sump the
recommended delime agent recommended by your
local detergent/chemical supplier.
•
Close the door(s)
•
Press the de-lime switch to the ON position.
•
The pump will start and continue to operate until
the delime switch is pressed to the OFF position.
•
The cycle light will be lit while the delime switch is
in the ON position.
•
After the delime cycle has been performed operate
at least one wash cycle without any glassware in
the unit.
•
Note pump stops when door is opened but cycle
does not stop.
MANUAL FILL/DRAIN
•
The front of the control panel contains a manual fi ll
and drain switch.
•
Pressing this switch to the top position the unit will
fi ll with water.
•
Pressing this switch to the bottom position the unit
will drain.
•
Do not operate a WASH or DELIME cycle after
pressing the drain switch.
STD/EXT WASH
•
This switch determines the length of the wash
cycle.
•
STD position uses the standard 90 second cycle.
•
EXT position uses the extended 150 second cycle.
ADDING RINSE AID, SANITIZER, &
DETERGENT
The machine is supplied with a chemical dispensing
system that is internally wired and ready for
use. Position the chemical bottles close to the
Glasswasher making sure that they will not be prone
to being knocked over or interfere with normal activity
around the Glasswasher. Insert the color coded
pickup tubes into the correct containers.
GW_40TM09
®
13
PART 3 OPERATING INSTRUCTIONS
The RED tube is for a non chlorinated, non foaming,
commercial detergent recommended for your
Glasswasher by your local detergent/chemical
supplier.
The CLEAR/WHITE tube is for a chemical sanitizer
using a sodium hypochlorite solution or a iodine
based sanitizing solution, as recommended by your
local detergent/chemical supplier.
The BLUE tube is for a low temperature rinse aid
recommended by your local detergent/chemical
supplier.
A priming push button switch for each of the
chemicals is located on the front of the control
box. Press and hold the priming switches until the
chemical is seen being dispensed into the wash
sump.
A speed potentiometer is located on the underneath
side of the control box for adjusting the delivery of
the chemicals. This adjustment should be left for a
qualifi ed person to perform.
CAUTION:
Only use detergent and rinse aid which are suitable
for commercial washers, a non-foaming industrial
alkaline detergent.
Do not use any soap intended for a residential
dishwasher. This leads to large amounts of foam
building up in the washer and will void your
manufacturers warranty.
CAUTION:
Detergents for commercial dishwashers
cause corrosion. Always follow the instructions
on the packaging and drums.
CAUTION:
Do not mix different detergent products,
this could cause the dosing pump to break down
due to crystallization.
www.insingermachine.com
800-344-4802
Advertisement
