Single Application Applock - Honeywell VX6 Reference Manual

Introduction

Single Application AppLock

A mobile device running the Single Application version of AppLock becomes a dedicated, single
application device. In other words, only the application or feature specified in the AppLock
configuration by the Administrator is available to the user.
If your Administrator Control Panel has Control, Security and Status tabs, then the device has
LXE's Single-Application AppLock installed.
application to lock and the end user is limited to that application.
Though this chapter is designed for users of the newer Multi-Application AppLock, the
instructions may also be used to configure Single-Application AppLock with the following
differences:
• The Control tab is used to specify the application to lock instead of the Application tab.
While the Application tab contains provisions for multiple applications, the Control tab
only allows the administrator to specify a single application.
• The section on End User Switching Technique does not apply to this version.
• Some configuration items may not be available.
E-EQ-VX6RG-F
Figure 6-2 Single-Application AppLock
The Administrator can configure a single
VX6 Reference Guide
265