270
Application Configuration
The default Administrator Hotkey sequence is
Administrator mode allows access to all features on the device. When the hotkey is pressed to
switch into Administrator mode, a password prompt is displayed (if a password has been
configured). A password must be entered within 30 seconds (and within three tries) or the
password prompt is removed and the device remains in end-user mode with the focus returned to
the locked application. Without entry of a valid password, the switch into Administrator mode
will not occur.
Access:
The password prompt is displayed if a password has been configured. When the valid password is
entered, the Administration Control panel is displayed. When a valid password is not entered
within 30 seconds, the user is returned to the System Control Panel.
If a password has not been configured, the Administrator Control panel is displayed.
Important: Before setting up multiple instances of the same application, make sure the
targeted software application will allow two instances to run at the same time.
Application Panel
Note:
Note:
Single Application version.
Use the Application tab options to select the applications to launch when the device boots up in
End-user Mode.
If no application is specified when the Administrator Control Panel is closed, the mobile device
reboots into Administrator mode. If a password has been set, but an application has not been
VX6 Reference Guide
Settings | Control Panel | Administration icon
Users of Single-Application AppLock have a Control tab instead of an Application tab.
Some of the options in this section do not apply to the Control tab.
Figure 6-4 Application Panel
If your Application Panel does not look like the figure shown above, you may have the
Single Application version.
Application Configuration
Shift+Ctrl+A.
E-EQ-VX6RG-F