Logon Options; Single Signon; Pre-Logon Connection - Honeywell Thor VX9 User Manual

Logon Options

There are two options available, a single signon which uses the Windows username and password as the credentials
for 802.1x authentication and pre-logon which used saved credentials for 802.1x authentication before Windows logon.
If either option is enabled, the credentials entered here take precedence over any credentials entered on the Profile
tab.
To use either option, select Logon Options on the Profile tab. The Logon Options button is displayed.
Click the Login Options button.

Single Signon

To use the Single Signon option, select the checkbox for Use the Windows username and password when
available. When the active profile is using LEAP, PEAP-MSCHAP, PEAP-GTC or EAP-FAST, the SCU ignores the
username and password, if any, saved in the profile. Instead, the username and password used for Windows
logon is used. Any certificates needed for authentication must still be specified in the profile.
Click OK then click Commit.

Pre-Logon Connection

To use the Pre-logon connection, select the checkbox for Enable pre-logon connection. This option is designed to
be used when:
• EAP authentication is required for a WLAN connection
• Single Signon is configured, so the Windows username and password are used as credentials for EAP
authentication
• The WLAN connection needs to be established before the Windows login.
Once this option is enabled, the Authentication delay and Association timeout values can be adjusted as nec-
essary. Both values are specified in milliseconds (ms).
The default authentication delay is 5000 ms and the valid range is 0 - 600,000 ms.
The default association timeout is 10,000 ms and the valid range is 10,000 to 600,000 ms.
Click on the Credentials button to enter the logon credentials.
5 - 47