Bluetooth Barcode Reader Setup; Introduction; Vx6 With Label; Figure 1-8 Sample Bluetooth Address Barcode Label - Honeywell VX6 Reference Manual

18

Bluetooth Barcode Reader Setup

Please refer to the Bluetooth scanner manufacturer's User Guide; it may be available on the
manufacturer's web site. Contact your LXE representative for Bluetooth product assistance.

Introduction

LXE supports several different types of barcode readers. This section describes the interaction and
setup for a mobile Bluetooth laser scanner or laser imager connected to the VX6 using Bluetooth
functions.
• The VX6 must have the Bluetooth hardware and software installed. An VX6 operating
system upgrade may be required. Contact your LXE representative for details.
• If the VX6 has a Bluetooth address identifier barcode label affixed, then Bluetooth
hardware and software is installed.
• The mobile Bluetooth laser scanner / laser imager battery is fully charged.
• The VX6 batteries are fully charged. Alternatively, the VX6 may be in a powered cradle or
cabled to AC/DC power.
• The barcode numbering examples in this segment are not real and should not be created
nor scanned with a Bluetooth scanner.
• To open the LXEZ Pairing program, tap Start | Settings | Control Panel | Bluetooth or
tap the Bluetooth icon on the desktop or tap the Bluetooth icon in the taskbar.
Locate the barcode label, similar to the one shown above, attached to the mobile device. The label
is the Bluetooth address identifier for the VX6.
The mobile Bluetooth scanner / imager requires this information before discovering, pairing,
connecting or disconnecting can occur.
Important: The VX6 Bluetooth address identifier label should remain protected from damage
(rips, tears, spills, soiling, erasure, etc.) at all times. It may be required when pairing, connecting,
and disconnecting new Bluetooth barcode readers.

VX6 with Label

If the VX6 has a Bluetooth address barcode label attached, follow these steps:
1. Scan the Bluetooth address barcode label, attached to the VX6, with the LXE Bluetooth
mobile scanner.
2. If this is the first time the Bluetooth scanner has scanned the VX6 Bluetooth label, the devices
are paired. See section titled "Bluetooth Beep and LED Indications". If the devices do not
pair successfully, go to the next step.
3. Open the LXEZ Pairing panel [Start | Settings | Control Panel | Bluetooth].
4. Tap Discover. Locate the Bluetooth scanner in the Discovery panel.
VX6 Reference Guide
LnkB00440fd01020 - Sample

Figure 1-8 Sample Bluetooth Address Barcode Label

Bluetooth
E-EQ-VX6RG-F