206
LEAP without WPA Authentication
To use LEAP (without WPA) make sure the following profile options are used:
Please see "WPA/LEAP" later in this section to configure the radio for WPA LEAP.
Please review "Sign-On vs. Stored Credentials", earlier in this chapter.
VX6 Reference Guide
•
Enter the SSID of the Access Point assigned to this profile
•
Set EAP Type to LEAP
•
Set Encryption to Auto WEP
•
Set Auth Type as follows:
If the Cisco/CCX certified AP is configured for open authentication, set the
o
Auth Type radio parameter to Open.
If the AP is configured for network EAP only, set the Auth Type radio
o
parameter to LEAP.
Figure 5-15 LEAP Configuration
Summit Radio
E-EQ-VX6RG-F