Wpa/Leap - Honeywell Thor VX9 User Manual

WPA/LEAP

To use WPA/LEAP, make sure the following profile options are used.
1. Enter the SSID of the Access Point assigned to this profile
2. Set Auth Type as follows:
• If the Cisco/CCX certified AP is configured for open authentication, set Auth Type to Open.
• If the AP is configured to use shared key or passphrase, set Auth Type to Shared.
3. Set WPA as follows:
• Select WPA/WPA2 to use either TKIP/AES or AES-CCMP
• Select WPA2 to use AEX-CCMP
4. Set Encryption to either TKIP/AES or AES-CCMP depending on WPA type selected
5. Set Authentication to LEAP
See Sign-On vs. Stored Credentials
Scroll down to enter credentials. No entries are necessary for Sign-On Credentials as the user will be prompted for the
Username and Password when connecting to the network.
Enter the Domain\Username (if the Domain is required), otherwise enter the Username.
5 - 24
(page 5-13) for information on entering credentials.