Doorphone Voip Operation; Signaling Overview; Visitor At Door - Alphatech Slim IPDP – 01 Installation And Operating Instructions Manual

2 DoorPhone VoIP Operation

2.1 Signaling Overview

The IPDP signals an acoustic conditions they may occur during
operation. Another signaling can be done by means of red LED (placed under
microphone hole).
program.
Condition
Line lifting up
Line hanging up
Report after calling
Notice about call end
Parameter confirmation
Switch on (Reset)
Error (anything, if unsuitable)
Empty memory (no progr. numb.)
Waiting to talk
Is talk

2.2 Visitor at Door

The IPDP function is influenced by setting of IPDP parameters.
The DoorPhone buttons are provided by nameplates or positions of
persons inside the object. The incoming person will press the corresponding
button, the DoorPhone will lift up the VoIP canale neither immediately (the
button is not the first number from code lock), or with delay and dial the
programmed phone number thru VoIP, but dial number differs by choice mode,
which is set in the DoorPhone :
- Day/night mode = being the DoorPhone in Day mode, so it is always
dialing a number set in table 1, in Night mode, it is always dialing a
number set in table 2. . Switching is possible use manual (two codes)
or automatic (table "Day intervals") and here you can set the switch
to three day intervals for 7 days a week. To facilitate proper function
is to set the IP address of the NTP server and network settings so
that the DoorPhone IPDP should have access to the Internet. In
automatic mode, day / night mode is also possible to use a
temporary manual switch, which cancels the first passage of the next
automatic switching interval.
You can listen the signaling samples in Nset setting
Tones
–▄–■–▀–
–▀–■–▄
–▄–■–▀–
–■–■–■–
––█––
–■–▄–■–
–■–■–■–■–■–■–
–█–▄–■–▄–■–▄–
-
-
Tone frequency
425-850-1275
1275-850-425
425-850-1275
1275
1275-850-1275
425....
850-1275-1700...
-
-
IPDP - installation and operating instructions
LED
Light
Dark
Light
Light
Blink
Blinking
light
15