Preparation (Setting Parameters) - A&D HV-60KGL-WP Instruction Manual

Function
table
F67
Caution
The upper limit value (HI) must be greater than the lower limit value (LO).
The parameters of the upper limit value (HI) and the final value (HI) use the
same memory. The parameters of the lower limit value (LO) and the zero band
(LO) use the same memory.
The upper/lower comparator function, the simple batch function and the
full/dribble batch function can not be used at the same time because these
parameters use common memory.

11.1. Preparation (Setting Parameters)

Step 1 Turn off the display.
Press the
and held. F1 is displayed.
Step 2 Press the
displayed.
Step 3 Select a parameter of the comparator function
(
f6 0
Step 4 Press the
Step 5 Press the
function mode. The scale returns to the weighing
mode.
The comparator is permanently activated and compares stable
values only, except those near zero.
key while the
ON/OFF
key repeatedly until F6 is
ENTER
~ ) with the
f6 7
key to store the new parameter.
ENTER
key and the
F ENTER
Meaning and purpose
key is pressed
ZERO
key.
∧
key to exit from the
Page 30
A
A
A
A
HVG-WP Series