Data Output - A&D HV-60KGL-WP Instruction Manual

The following explanation uses "format 1 ( f15 0 )" assuming 23 as the address.

Data output

The current weighing data is output.
Template
Command
Reply
Selection of mode and unit
Selects the mode and unit. This is the same as the
Template
Command
Reply
Zero
The current mass value is set to the zero point.
This is the same as the
Template
Command
Reply
Tare
The current mass value becomes zero after placing a tare (receptacle, case, etc) and
the net is displayed. This is the same as the
Template
Command
Reply
Cancel of tare
The display value becomes the gross and the net mark is turned off. (The tare value
becomes zero.)
Template
Command
Reply
Preset tare
The tare value is set and the net value is displayed. The net mark is displayed.
Template
Command
Reply
Upper limit value
An upper limit value is stored.
Template
Command
Reply
Lower limit value
A lower limit value is stored.
Template
Q
U
The scale changes mode and unit.
key.
ZERO
Z
The mass value becomes zero and the zero point mark is displayed.
T
The current mass value becomes zero and the net mark is displayed.
CT
Gross is displayed and the net mark is turned off.
PT, [parameter]
Net is displayed.
HI, [parameter]
The upper limit value is stored.
LO, [parameter]
MODE
key.
TARE
Page 62
key.
17.3. OP-04, Options
HVG-WP Series