Functions; The Procedure For Setting Parameters.14 - A&D FG Series Instruction Manual

_9. FUNCTIONS_
The scale has Function settings to expand your applications.
The parameters set in the Function settings are maintained even if the power switche<
off.
/'"■ 1
r
r
V.
—Jw--
i
\ Item \ Parameter
9-1. The procedure for setting parameters
1. Turn the power off.
2. Press and hold the [ ZERO 1 switch and turn the
power on via the [ ON/OFF 1 switch. Then, the first
function item and its parameter is displayed.
3. Set the parameter value using the 1 PRINT | switch.
□ If you do not need to change the parameter, go to next
step without setting.
4. Press the MODE switch. Then the display goes to
the next function item.
O In this stage, the new parameter is not stored in
the scale yet.
O To end changing the parameters, turn the power
off.
5. Repeat the steps 3 and 4 to the last item.
6. After setting the last item, press the 1 MODE | switch,
Then, | End [ will appear.
7. Press the MODE | switch again. The parameters are
stored in the scale, and the scale will automatically boot
up.
O If you turn the power off before this step is done,
none of the parameters will be changed.
14