Installing The Op-03 - A&D HV-60KGL-WP Instruction Manual

17.2.1.

Installing the OP-03

Caution Do not pull on the connected cables
while opening the rear panel.
Step 1 Remove the plastic panel from the option
board.
Step 2 Remove eight pairs of screws and O rings
from the indicator unit. Open the rear panel
of the unit.
Step 3 Remove the standard interface board from
the indicator unit. Install the option board at
the same position.
Step 4 Connect the cable to the J1 connector on
the option board.
Step 5 Connect the DIN plug to the option board.
Step 6 Close and secure the rear panel using the
screws and O rings removed at step 2.
Page 58 HVG-WP Series