Functions; The Procedure For Setting Parameters - A&D FS-i Series Instruction Manual

The scale has Function settings to expand your applications.
The parameters set in the Function settings are maintained even if the power switched
off.
Function number

11-1. The procedure for setting parameters

1. Turn the power off.
2. Press and hold the ZERO key and turn the power
on via the
number is displayed.
3. Enter the Function number using the 10-ley pad.
4. Press the ENT key. Then the parameter stored is
appears.
3. Enter the parameter value using the 10-ley pad.
If you do not need to change the parameter, turn the
power off without pressing ENT key.
If you like to go to the next function number, press the
ZERO key and set the new parameter if necessary.
4. Press the ENT key. The display shows
a few seconds and returns to weighing mode.
Be sure to press the ENT key because all of the new
parameters are not stored until

11. FUNCTIONS

-f01-01
ON/OFF key. Then the fist function
end
Parameter
end
for
is displayed.
24
-f01-01
-f07-01
-f07-01
-f07-00
-f08-01
-00end00