Function Settings; Setting The Parameters - A&D SJ-3000WP Instruction Manual

The scale has function settings to specify the scale performance.
The parameters set in the function settings are maintained even if the power is turned
OFF.
Item

11.1. Setting the parameters

1. Turn the power OFF.
2. Touch and hold the
the
software version is displayed.
"∗∗∗" indicates the software version number.
3. After about one second, the item is displayed.
4. Change the item or parameter using the following switches.
UNITS
SAMPLE
5. Tap the
TARE
After displaying "
mode.
To cancel the setting procedure without storing the value,
touch and hold the

11. FUNCTION SETTINGS

TARE
switch to turn the power ON. The
To display the next item.
To increase the value of the blinking
digit by one (to change the parameter).
When the parameter is changed,
the STABLE indicator turns off.
switch to store the setting value.
end
", the scale goes to the weighing
switch to turn off the scale.
Parameter
switch and touch
20
While
touching & holding, Touch
Tap
When changed
Tap