Firmware Upgrade - Digimerge VB300 SERIES Instruction Manual

ADVANCED SETUP (cont'd.)
DVR MENU SETUP (cont'd.)
To restore factory defaults:
1. From the ADVANCED SETUP menu,
select MENU INTIALIZE and press the
button. The Menu Initialize screen
opens.
2. Select YES to restore factory defaults and
press the button. Select NO and press
the button or press the
cancel.
3. Press the button on the remote
control until you see the Save/Exit screen.
Select SAVE ONLY or SAVE AND EXIT
to save your settings.
ATTENTION: Running MENU INITIALIZE
restores only system settings. Recorded
video data on the hard disk is not affected.

FIRMWARE UPGRADE

Firmware upgrades can help improve the
functionality of your system. Check the
manufacturer's website for the availablity of
firmware upgrades.
To perform a firmware upgrade:
1. Insert a USB flash drive into the USB port
on the front panel of the system.
2. From the ADVANCED SETUP menu,
select FIRMWARE UPGRADE and press
the
button to
3. Select YES to perform a formware
upgrade fron the USB port on the front
panel and press the
and press the
button to cancel.
ATTENTION: You can only perform a
firmware upgrade from the USB port on
the front panel. DO NOT use the USB
ports on the rear panel to perform
firmware upgrades.
Using the Main Menu
button.
button. Select NO
button or press the
47