Table of Contents
Advertisement
Using the Main Menu
LINK
Open the Link menu to configure the following options:
• NETWORK
• RS485
• PTZ
• E-MAIL
Note: Some networking knowledge is suggested when configuring options in the Link menu.
NETWORK
Configure networking and DDNS options.
DDNS service is required for some of the
following network options.
Figure 13.0 Advanced Setup menu
Note: Make sure you have connected an
Ethernet cable (not included) to the rear
panel of the system to make use of the
networking functions of the system.
• DHCP and other networking options:
Configure the settings DHCP (Dynamic
Host Configuration Protocol) settings. This
affects how your system communicates
with the router.
Note: DCHP Mode allows you to quickly
connect the first time by obtaining an IP
address from the router. After the initial
setup, we recommend that you set DHCP
to OFF and set the IP address between
1~100. For example, if your IP address is
192.168.0.107, change the last digits to 50
(i.e. 192.163.0.50).This ensures that port
48
• DVR NAME
• DVR LOCATION
• BANDWIDTH
• DYNAMIC DNS
forwarding will not change in the event of
power failure or resetting of your network.
• PORT: By default, 5400 is the TCP port of
the system.
Note: The port number on the system must
be the same as that in the client software.
Note: If you use a PPPoE network, you must
use a router to connect the system to the
Internet, as this unit does not use PPPoE
protocol.
• NETWORK FRAME: Press the
buttons to select STILL, MOTION, or GOP
(Group of Pictures).This sets the type of
image to be sent from the DVR to the
remote client software.
Advertisement
Table of Contents
