Event Screen Mode; Event Check; Event Message; Event Buzzer - Digimerge VB300 SERIES Instruction Manual

Using the Main Menu

EVENT SCREEN MODE

Set the type of on-screen display when an
event is triggered.
Figure 11.2 Event menu—Event Screen Mode
To set the event screen mode:
1. From the Event menu, press the the
buttons to select EVENT SCREEN
MODE.
2. Press the press the
the value for the Event Screen Mode:
• SCREEN HOLD: The current screen
remains displayed even if an event is
triggered.
• EVENT FULL: Display the channel for the
triggered event in full-screen.
• EVENT MULTI: Display the channel(s) for
the triggered event in multi (split)-screen.
• EVENT F_RTN: Display the channel for
the triggered
momentarily but then return to the
previous screen.
• EVENT M_RTN: Display the channel(s)
for the triggered
(split)-screen momentarily
returns to the previous screen.
40
buttons to change
event in full-screen
event in multi
and then
3. Press the button on the remote
control until you see the Save/Exit screen.
Select SAVE ONLY or SAVE AND EXIT
to save your settings.

EVENT CHECK

Enable/disable the system to record only when
events are detected.
From the EVENT menu, press the
to set ON/OFF.

EVENT MESSAGE

Enable a warning message to display
on-screen when an event occurs.
From the EVENT menu, press the
to set ON/OFF. If set to ON, a warning
message appears when an event occurs.

EVENT BUZZER

Enable an audio signal when an event occurs.
From the EVENT menu, press the
to set ON/OFF.
buttons
buttons
buttons