Replacing The Hard Drive - Digimerge VB300 SERIES Instruction Manual

Replacing the Hard Drive

To replace the hard drive:
1. Carefully position the new hard drive on the mounting
plate—the raised contour of the mounting plate should
be facing up (see figure 19.1)—and secure with the
four screws.
2. Place the mounting plate (with attached hard drive) on
the four mounting posts of the circuit board. Observe
that the mounting plate has an inset to allow for correct
placement on the circuit board (see figure 19.2).
3. Secure the mounting plate (with attached hard drive) to
the four mounting post with the four screws.
4. Reconnect the cables to the hard drive. Make sure the
cables are connected firmly.
5. Carefully replace the housing and reattach the four
screws—housing and screws holes should line up.
6. Reconnect all cameras and cables. Re-mount the unit
the back of your monitor if desired.
7. Power on the system. If you have installed a new hard
drive, you must format the drive before using the
system.
Appendix 9: Replacing the Hard Drive
Figure 19.1 Observe the raised contour
Figure 19.2 Replace the drive and mounting plate
Figure 19.3 Firmly reconnect the drive cables
73