Table of Contents
Advertisement
Basic Setup
Basic Setup
The Blade DVR is designed to mount securly to the back of LCD monitors with a VESA mount.
However, if desired, you can also leave the Blade DVR in a standard horizontal position.
ATTENTION: You can only mount the Blade DVR to an LCD
monitors with a VESA mount and an independent stand.
1. Mount the Blade DVR
a.Position the mounting plate on the back of the
LCD monitor (with a VESA mount) until mounting
holes on the back of the monitor are clearly
visible. Use the included screws to fasten the
mounting plate tightly to the monitor—make sure
the hooks are facing up.
b.Carefully place the Blade DVR (front panel facing
up) over the hooks and slide down into place. The
Blade DVR should be flush against the mounting
plate and sitting completely over all four hooks.
2. Connect the Cameras
a.Connect up to eight BNC cameras to the ends of
the included octopus cable. Connect the VGA
termination of the octopus cable to the Camera In:
Ch. 1~8* port on the rear panel of the Blade DVR.
3. Connect a DVI monitor
a.Connect the included DVI cable from the DVI port
on the rear panel of the Blade DVR to the DVI port
on the back of your LCD monitor.
Note: Use the included DVI-to-VGA adaptor to
connect to a VGA monitor.
4. Connect the IR Extender
a.Connect the IR extender to the port on the front
panel of the DVR. Position the IR extender near
the front of your monitor, or where it will receive a
clear signal from the remote control.
*16-channel model includes two octopus cables to connect up to 16 cameras.
6
Figure 1.0 Attach the mounting plate to the monitor
Figure 1.1 Mount the Blade DVR to the monitor
Figure 1.2 Connect the IR extender
Advertisement
Table of Contents
