Table of Contents
Advertisement
EVENT
Open the Event menu to configure the following options:
MOTION DETECTION
Configure motion detection for all camera
channels.
Figure 11.0 Motion Detection grid
To set motion detection:
1. Under CHANNEL, press the
to select the channel for which to set
motion detection.
2. Under SENSITIVITY, press the
buttons to set the motion sensitivity from
1~5. The higher the sensitivity, the the
more sensitive the detection.
3. Under AREA SETUP, press the
button to open the Area Setup Grid.
4. Press the
select cells on the grid. Press the
button to enable/disable the cell. When
finished, press the
Area Setup Grid.
• MOTION DETECTION
• EVENT SCREEN MODE
• EVENT CHECK
• EVENT MESSAGE
buttons
buttons to
button to exit the
• EVENT MESSAGE RESET
• EVENT BUZZER
• SENSOR INPUT
• RELAY OUTPUT
Figure 11.1 Motion grid setup
Note: An enabled (active) cell is clear; a
disabled (inactive) cell is green.
5.
Under TEST MOTION, press the
button to test your motion detection
settings. To verify your settings, wave your
hand in front of the selected camera:
active cells will appear pink while inactive
cells will appear green.
6. Press the
button on the remote
control until you see the Save/Exit screen.
Select SAVE ONLY or SAVE AND EXIT
to save your settings.
Using the Main Menu
39
Advertisement
Table of Contents
