Download Setup From Usb; Upgrading The System Firmware; Information - Digimerge DH100 Series Instruction Manual

Download Setup from USB

After you have copied the system settings to a
USB key, you can download the settings to the
DVR.
To download system settings to your DVR:
1. Insert the USB key that contains the
system backup settings.
2. Click Download Setup from USB
3. Click Yes to begin copying the settings to
your system.

Upgrading the system firmware

To upgrade the system firmware:
1. Download the firmware from
www.digimerge.com from the DH100's
product page.
2. Copy the firmware to a USB key.
Ensure only the firmware is in the
NOTE:
USB key. A firmware file name looks like
this: sdvr11z.fw
3. Insert the USB key to the front or rear
panel of the system.
4. Click the UPGRADE button.
5. Select the firmware from the list.
6. Click Yes to begin the firmware upgrade.
7. The system beeps several times, and the
screen turns black. This is normal.The
screen will remain black for up to 5
minutes, then beep again.
Wait for the system to boot into the main
viewing mode for the firmware upgrade to
complete. Once the system boots into live
mode, the firmware is updated.
Do not remove the USB key during the
NOTE:
firmware update process.

Information

• Click the Information button to display
network and hard drive information, and
firmware version.
• You can also access the Information
window by pressing the 10+ button on the
remote control.
Using the Main Menu
41