Quick Start; About Lithium-Ion Batteries - LXE MX3X User Manual

4

Quick Start

This section's instructions are based on the assumption that your new system is pre-configured and
requires only accessory installation (e.g. hand strap, external barcode scanner) and a power
source.
This guide takes you through an introduction to and daily use of the LXE MX3X.
In general, the sequence of events is:
1. Insert a fully charged battery. (Always put a fully charged battery in the MX3X at the
beginning of the shift or workday.)
2. Connect an external power source to the unit (if required).
3. If the screen does not automatically display, tap the Power button.
4. Adjust screen display, audio volume and other parameters if desired.
Note: Do not connect a tethered scanner cable to an MX3X USB-C or USB-H labeled endcap
port. These ports cannot power a tethered scanner.

About Lithium-Ion Batteries

Li-Ion batteries (like all batteries) gradually lose their capacity over time (in a linear fashion) and
never just stop working. This is important to remember -- the MX3X is always 'on' even when in
the Suspend state and draws battery power at all times. Use the Start | Settings | Control Panel |
Power | Battery tab to check the battery status and power reading.
Always replace the used Main Battery with a fully charged Main Battery. The Battery Low
Warning LED illuminates red at approximately 35% of power left in the Main Battery. You need
to determine the point at which battery life becomes unacceptable for your business practices and
replace the Main Battery pack before that point.
MX3X User's Guide
Quick Start
E-EQ-MX3XOGWW-A