Important Battery Charger Version Information; Battery Chargers Affected; Battery Label Location - LXE MX3X User Manual

Charge Battery in LXE Multi-Charger Plus

Important Battery Charger Version Information

Battery Chargers Affected

The MX3X Main Battery Pack may be incompatible with MX3 Battery Chargers that have not
been upgraded to V1.20 or V1.01. To successfully charge the MX3X Battery Pack, pre-existing
MX3 Battery Chargers must be returned to LXE for a software upgrade.
Using a Multi-Charger Plus Battery Charger with the MX3X Battery Pack
The MX3X device is designed to use a 2.2Ahr Main Battery Pack to achieve 8+ hours of
continuous operation.
If the MX3X battery pack is inserted into a MX3 Multi-Charger Plus (without the V1.01 upgrade)
bay , the battery may not become fully charged in the 4 hour time limit and a red LED illuminates
after 4 hours have elapsed indicating a Battery Problem.
Remove and reinsert the MX3X battery pack into the same charging bay. This will reset the timer
and allow the charger to complete the charge cycle for the battery in approximately 2 hours..

Battery Label Location

The MX3X battery pack has a silver label (see the figure below for the location of the label on the
main battery packs).
E-EQ-MX3XOGWW-A
MX3 Multi-Charger Plus
9000A377CHGR5
Use LXE V1.01 Upgrade Kit
LXE does not supply an external timing
device with the Multi-Charger Plus.
MX3 Multi-Charger
MX3A378CHGR6
(Not Available After 7-2003)
Use LXE V1.20 Upgrade Kit
125 Technology Parkway
Norcross, GA 30092 USA
!
Risk of fire, explosion, or burns. Do not short circuit, crush, heat above
100 C, incinerate or disassemble the battery.
19
MX3X User's Guide