Quick Start; Troubleshooting; About Lithium-Ion Batteries - LXE MX3X User Manual

Quick Start

Quick Start
If the mobile device has AppLock installed, please refer to "MX3X Reference Guide",
Note: When your mobile device is pre-configured, the radio, PCMCIA card and endcaps are
assembled by LXE to your specifications.
This section's instructions are based on the assumption that your new system is pre-configured
and requires only accessory installation (e.g. handstrap, stylus) and a power source. LXE
recommends that installation or removal of accessories be performed on a clean, well-lit surface.
When necessary, protect the work surface, the mobile device, and components from electrostatic
discharge.
This guide takes you through an introduction to and operation of the MX3X with and without the
RFID module.
In general, the sequence of events is:
1. Insert a fully charged battery and press the Power button.
2. Connect an external power source to the unit (if required).
3. If the screen does not automatically display, press the Power button.
4. Adjust screen display, audio volume and other parameters if desired.
Note: Do not connect a tethered scanner cable to a USB-C or USB-H labeled endcap port.
These ports cannot power a tethered scanner.

Troubleshooting

Can't align the screen, change the
date/time or adjust the volume.

About Lithium-Ion Batteries

Li-Ion batteries (like all batteries) gradually lose their capacity over time (in a linear fashion) and
never just stop working. This is important to remember – this mobile device is always 'on' even
when in the Suspend state and draws battery power at all times. Use the Start | Settings | Control
Panel | Power | Battery tab to check the battery status and power reading.
Always replace the used main battery with a fully charged main battery. The Battery Low
Warning LED illuminates red at approximately 35% of power left in the main battery. You need to
determine the point at which battery life becomes unacceptable for your business practices and
replace the main battery before that point.
Note: Until the main battery and backup battery are completely depleted, the mobile device is
always drawing power from the batteries (On).
E-EQ-MX3XOGWW-D
"AppLock" for setup and processing information before continuing.
AppLock is installed and running on the mobile device.
AppLock restricts access to the control panels. Contact
your System Administrator.
Important
7
MX3X User's Guide