Quick Start; In Brief; Figure 8 Mx7 Desktop - LXE MX7 User Manual

In Brief . . .

Note: When your mobile device is pre-configured, the radio, keypad and scan aperture
configurations are assembled by LXE to your specifications. The desktop will display an
Odyssey Client Utility icon or it will display a Summit Client Utility icon.
This section's instructions are based on the assumption that your new device is pre-configured and
requires only accessory installation (e.g. stylus) and a power source. LXE recommends that
installation or removal of accessories be performed on a clean, well-lit surface. When necessary,
protect the work surface, the mobile device, and components from electrostatic discharge.
This guide takes you through an introduction to and operation of the MX7.
1. Insert a fully charged main battery pack. (Always put a fully charged battery in the
mobile device at the beginning of the shift or workday.)
2. Connect an external power source to the unit (if required).
3. If the screen does not automatically display, tap the Power key.
4. Calibrate the touchscreen.
5. A white screen will appear during the boot process until all CAB files and applications
are loaded and installed. Radio setup screens may appear and disappear while files are
loading. After all files are loaded and the Desktop is displayed, adjust audio volume and
other parameters if desired.
If needed, change the Time and Date from it's default value by tapping the
Panel | Date/Time icon.
E-EQ-MX7OGWW-C

Quick Start

MX7 with Odyssey Client

Figure 8 MX7 Desktop

| Settings | Control
MX7 with Summit Client
MX7 User's Guide