Operation; Quick Start; Power Up; Please Wait" Messages - LXE MX2 User Manual

Hide thumbs Also See for MX2:

Table of Contents

Operation

This section's instructions are based on the assumption that your new MX2 is pre-configured and

requires only a power source.

In general, the sequence of events is:

1. Turn the battery compartment dial counter-clockwise. Remove cover and set aside.

2. Insert NiMH battery. Replace the battery cover and turn the compartment dial clockwise

3. Turn the MX2 on by pressing the Power key. A battery icon is displayed at the top right

4. Turn the MX2 off by pressing the Power key again.

The first time you turn the unit on, you may see the following message:

Initial power-up or

critical data loss.

Drive D formatted.

Press any key...

This message appears with normal operation and does not indicate a problem. Just press the

[Enter] key, and the unit will continue to boot up.

This message will also appear when you place new or recharged batteries in the unit after the

backup battery has been drained. Again, this is normal and not a problem.

With certain types of PC cards installed, the MX2 performs various operations on the card

whenever you turn it on or off. While these operations are happening, the unit displays a message

in reverse video indicating that it is powering on or off. When turning the unit on, wait until the

message disappears before using the unit. When turning the unit off to replace the batteries, wait

until the message disappears before removing the batteries.

E-EQ-MX2OGWW-K-ARC

Battery full icon

to lock.

corner of the display when the MX2 is running with a charged battery.

Power key, 38-key keypad

Power key, 48-key keypad

MX2 User's Guide

Table of Contents