Quick Start; Figure 3 Hardware Configuration - LXE MX3-CE User Manual

4

Quick Start

This section's instructions are based on the assumption that your new system is pre-configured and
requires only accessory installation (e.g. hand strap, external barcode scanner) and a power
source.
Use this guide as you would any other source book -- reading portions to learn about the MX3-
CE, and then referring to it when you need more information about a particular subject. This guide
takes you through an introduction to and operation of the LXE MX3-CE.
In general, the sequence of events is:
Troubleshooting
Can't align the screen, change the
date/time or adjust the volume.
MX3-CE User's Guide

Figure 3 Hardware Configuration

1. Insert a fully charged battery. (Always put a fully charged battery in the MX3-CE at
the beginning of the shift or workday.)
2. Connect an external power source to the unit (if required).
3. If the screen does not automatically display, tap the Power button.
4. Adjust screen display, audio volume and other parameters if desired.
AppLock is installed and running on the mobile device.
AppLock restricts access to the control panels. Contact
your System Administrator.
E-EQ-MX3CEOGWW-F-ARC
Quick Start