Figure 8-38. Removing Key.
Remove Backing Plate and Stator
1. Remove the four mounting screws and the
backing plate from crankcase. See Figure 8-39.
Figure 8-39. Removing Backing Plate.
2. Remove the two hex flange screws and the stator.
See Figure 8-40. Note the routing of the stator
leads.
Figure 8-40. Removing Stator.
Remove Outer Breather Assembly
1. RTV sealant is used between the outer breather
cover and the crankcase. Remove the hex nut and
sealing (flat) washer securing the breather cover
to the crankcase. Carefully pry under the small
tab of the cover flange to separate and remove.
Do not bend or distort the cover. See Figure 8-41.
Tab
Figure 8-41. Removing Outer Breather Cover.
2. Unscrew and remove the mounting stud, retainer
and breather reed. See Figure 8-42.
Figure 8-42. Removing Stud, Retainer, and
Breather Reed.
Remove Oil Pan Assembly
1. Remove the ten hex flange screws securing the oil
pan to the crankcase. See Figure 8-43.
Section 8
Disassembly
Stud
Retainer
Breather Reed
8.11
8