Kohler Courage SV710-740 Service Manual page 75

The stator is mounted on the crankcase behind
the flywheel. Follow the procedures in Section 8,
Disassembly and Section 10, Reassembly if stator
replacement is necessary.
The rectifier-regulator is mounted to the underside of
the backing plate on the oil filter side. See Figure 7-21.
To replace it, remove the two mounting screws and
disconnect the plug.
NOTE: When installing the rectifier-regulator, take
note of the terminal markings and install the
plug accordingly.
Testing of the rectifier-regulator may be performed
as follows, using the appropriate Rectifier-Regulator
Tester.
NOTE: Disconnect all electrical connections attached
to the rectifier-regulator. Testing may be
performed with the rectifier-regulator
mounted or loose. The figures show the part
removed from the engine for clarity. Repeat
the applicable test procedure two or three
times to determine the condition of the part.
1. Connect the tester ground lead (with spring
clamp) to the body of the rectifier-regulator being
tested.
2. Connect the tester red lead to the B+ terminal of
the rectifier-regulator and the two black tester
leads to the two AC terminals. See Figure 7-22.