4. Torque the hex flange screws in two stages; first
to 22.6 N·m (200 in. lb.), then finally to 41.8 N·m
(370 in. lb.), following the sequence in Figure
10-46.
1. Loosen the hex locking nut and back off the
adjusters for the rocker arms. If the adjusters for
the rocker arms were removed, reinstall them
into the threaded end of arm approximately three
threads and screw the hex locking nut onto the
adjuster from the underside. Screw adjuster flush
with the bottom of the nut as an initial setting.
Do not tighten the locking nut at this time, final
adjustment will be made later. See Figure 10-47.
2. Apply grease to the contact surfaces of the
adjusters, rocker arms and rocker arm pivots.
Install the rocker arms and rocker arm pivots
onto the appropriate cylinder head, and start the
two hex flange screws.
3. Hold the rocker arms in aligned position
and torque the hex flange screws to 11.3 N·m
(100 in. lb.). See Figure 10-48.