Kohler Courage SV710-740 Service Manual page 9

Normal maintenance, replacement or repair of emission control devices and systems may be performed by any
repair establishment or individual; however, warranty repairs must be performed by a Kohler authorized
service center.
•
•
•
•
• Service precleaner element
•
•
• Change oil and filter. (More frequently under severe conditions).
• Remove cooling shrouds and clean cooling areas¹.
• Check that all fasteners are in place and components are properly
• Replace fuel filter.
• Check spark plug condition and gap.
• Have valve lash checked/adjusted
• Have bendix starter drive serviced
•
• Replace spark plug.
If the engine will be out of service for two months or
more, use the following storage procedure:
1. Clean the exterior surfaces of the engine. Avoid
spraying water at the wiring harness or any of the
electrical components.
2. Change the oil and oil filter while the engine is
still warm from operation. See Section 6, Change
Oil and Oil Filter.
3. The fuel system must be completely emptied,
or the gasoline must be treated with a stabilizer
to prevent deterioration. If you choose to
use a stabilizer, follow the manufacturer's
recommendations, and add the correct amount
for the capacity of the fuel system.
Fill fuel tank.
Check oil level.
Check air cleaner for dirty
Check air intake and cooling areas, clean as necessary
Service air cleaner element (if not equipped with precleaner).
Replace air cleaner element
secured.
Have solenoid shift starter disassembled and cleaned
1 , loose, or damaged parts.
1
(if equipped).
1 (if equipped with precleaner).
2 .
2 .
Fill the fuel tank with clean, fresh gasoline. Run
the engine for 2 to 3 minutes to get stabilized
fuel into the rest of the system. Close the fuel
shut-off valve when the unit is being stored or
transported.
To empty the system, run the engine until the
tank and the system is empty.
4. Remove the spark plugs and add one tablespoon
of engine oil into each spark plug hole. Install the
spark plugs, but do not connect the plug leads.
Crank the engine two or three revolutions.
5. Disconnect the battery or use a battery minder to
keep the battery charged during storage.
6. Store the engine in a clean, dry place.
Section 5
Section 6
Section 4
1
. Section 4
Section 4
Section 4
Section 4
Section 6
Section 4
Section 5
Section 7
Section 10
Section 7
2
. Section 7
Section 7