Kohler Courage SV710-740 Service Manual page 140

1. Install a new carburetor gasket. Make sure all
holes align and are open.
2. Install the carburetor, throttle linkage and
governor lever as an assembly. See Figure 10-68.
3. If the carburetor is equipped with a fuel
solenoid, connect the red (power) lead. Attach
the eyelet terminal of ground lead to the inner
top carburetor cover mounting screw. See Figure
10-69.
1. Install the governor lever onto the governor cross
shaft if disconnected previously. See Figure 10-70.
2. Make sure the throttle linkage is connected to
the governor lever and the throttle lever on
the carburetor. Connect the choke linkage to
carburetor choke lever. See Figure 10-71.
3. Attach the fuel line to the carburetor and secure
with a clamp.
4. Install a new air cleaner base gasket and the air
cleaner base onto the mounting studs. Torque the
two hex flange nuts to 6.2-7.3 N·m (55-65 in. lb.).
See Figure 10-72.