Kohler Courage SV710-740 Service Manual page 144

4. If separated earlier, install the dipstick tube and
align the mounting hole with the threaded hole
in the lift bracket. Secure with the M5 hex flange
screw. Torque the screw to 4.0 N·m (35 in. lb.).
5. Install the oil fill cap/dipstick.
NOTE: Do not completely tighten screws until all are
installed to allow shifting for hole alignment.
1. Install the blower housing with the access door
onto the engine. Start all the mounting screws.
The two HI-LO thread screws are installed in
the front securing the blower housing to the air
cleaner base. Make sure the wire harness and
spark plug leads exit out through the appropriate
openings in the shrouding. Attach any fuel line
clamps used. See Figure 10-82.
2. Torque the screws as follows:
M5 Blower Housing Screws: 6.2 N·m (55 in. lb.)
in a new hole, or 4.0 N·m (35 in. lb.) in a used
hole.
M4 HI-LO Screws: 2.8 N·m (25 in. lb.).
1. Connect the pulse hose to the valve cover. The
valve cover should be situated between the two
formed lips on the pulse hose. See Figure 10-83.
2. Attach the pulse hose to the fuel pump and
secure with a clamp. Mount the fuel pump to the
blower housing with the two screws. Torque the
screws to 2.3 N·m (20 in. lb.).
3. Connect the inlet and outlet fuel lines to the
pump. Route inlet hose through the fuel line
clamp (if used) as shown, and seat outlet hose in
the blower housing clip. See Figure 10-84.
NOTE: If a new fuel pump is being installed,
make sure the orientation of the new
pump is consistent with the removed
pump. Internal damage may occur if
installed incorrectly.