1. Attach the outer cylinder baffles and secure with
the M6 screw (lower cylinder location), and M5
screw into the backing plate. See Figure 10-65.
Tighten the screws as listed following Step 2.
2. Attach the inner baffles including any lifting
straps to the cylinder head flanges and to the two
crankcase mounting bosses. The lift strap should
be outside the outer baffle. Secure with the M5
screws. See Figure 10-66. The remaining lower
inner baffle mounting screws will be installed
later.
Torque the baffle mounting screws:
M5 screws: 6.2 N·m (55 in. lb.) into a new cored
hole, or 4.0 N·m (35 in. lb.) into a used hole.
M6 screws: 10.7 N·m (95 in. lb.) into a new cored
hole, or 7.3 N·m (65 in. lb.) into a used hole.
3. Install the spark advance module (DSAM) if
equipped, onto the outer cylinder baffle. See
Figure 10-67.